pvc copper cable xhhw-2 wire AWG electrical stranded wire

 

 

xhhw-2 wire

pvc copper cable

hot sale  copper wire pvc insulation AWG electrical wire cable

electrical wiring

flexible wire

WIRE

Specification

XHHW-2

XLP Insulation, 600 Volts

1. SCOPE 1.1 This specification describes single conductor XHHW-2, a general purpose building wire insulated with

crosslinked polyethylene (XLP) intended for lighting and power circuits at 600 volts or less, in residential, commercial and industrial buildings. The wire may be operated at 90°C maximum continuous conductor tem- perature in wet or dry locations and is listed by Underwriters Laboratories for use in accordance with Article 310 of the National Electrical Code.

2. APPLICABLE STANDARDS 2.1 The following standards form a part of this specification to the extent specified herein:

2.1.1 2.1.2 2.1.3

Underwriters Laboratories Standard 44 for Rubber-Insulated Wires and Cables. ICEA Pub. No. S-95-658, NEMA Pub. No. WC70 for Nonshielded Power Cables Rated 2000 Volts or Less. Federal Specification J-C-30B.

3. CONDUCTORS 3.1 Conductors shall be Class B stranded annealed uncoated copper per UL Standard 44.

4. SEPARATOR 4.1 A suitable separator over the conductor may be used at the option of the manufacturer.

5. INSULATION 5.1 Each conductor shall be insulated with XLP, a crosslinked polyethylene complying with the physical and

electrical requirements of UL Standard 44 for Type XHHW-2. 5.2 The average thickness of insulation, for a given conductor size, shall be as specified in UL Standard 44 for Type

XHHW-2. The minimum thickness at any point shall be not less than 90% of the specified average thickness. The insulation shall be applied tightly to the conductor and shall be free-stripping.

6. IDENTIFICATION 6.1 The wire shall be identified by surface marking indicating manufacturer's identification, conductor size and metal,

voltage rating, UL Symbol and type designation.

7. TESTS 7.1 Wire shall be tested in accordance with the requirements of UL Standard 44 for Type XHHW-2.

8. LABELS 8.1 The wire shall bear the Underwriters Laboratories label for Type XHHW-2.

 

*Ampacity in accordance with NEC for not more than three conductors in raceway at the conductor temperature indicated, in wet or dry locations, 30°C ambient temperature.

6301 EAST STASSNEY LANE, SUITE 100 2-5 AUSTIN, TEXAS 78744, USA

 

APPLICATION: 1. General purpose wiring for lighting and power – residential, commercial,

industrial buildings in accordance with National Electrical Code, maximum conductor temperature of 90°C in wet or dry locations, 600 volts, for install- ation in conduit or other recognized raceways.

2. Suitable for use in low leakage circuits requiring a dielectric constant of 3.5 or less, such as isolated circuits supplying anesthetizing locations per Article 517-160 of the NEC.

3. Suitable for use as low leakage inductive (loop) vehicle detector wire in accordance with state and municipal requirements.

STANDARDS: 1. Listed by UL as Type XHHW-2 per Standard 44 for Rubber-Insulated Wires and

Cables. 2. Conforms to ICEA S-95-658/NEMA WC70, utilizing Column B thicknesses. 3. Conforms to Federal Specification J-C-30B.

CONSTRUCTION: Annealed copper conductor, XLP thermosetting chem- ically crosslinked polyethylene insulation, surface printed.

produce according to your request.