Copper conductor XLPE/PVC insulated Electric power extension cable low voltage underground armored cable

Copper conductor XLPE/PVC insulated Electric power extension cable low voltage underground armored cable

low voltage power extension cable LV underground armored cable

 

Application:

 

Applies to electrical power transmission and distribution lines with AC rated voltage Uo/ U up to and including 0.6/1kV.

For outdoor and indoor installation in damp and wet locations,laid directly in the ground where excessive mechanical stresses are present in sloping and moving terrains and in vertical or inclined laying,as well as in locations susceptible to sliding.

 

YJ: XLPE insulation

V: PVC insulation

V: PVC sheath

22: Galvanized steel tape armoring

32: Galvanized steel wire armoring

 

Construction:

 

Stranded (RM) bare copper as per IEC60228
Mica Tape for Fire-Proof
XLPE (cross-linked polyethylene) Insulation
Fillers strip, Yarn, or Paper
Non woven Wrapping tape or Flame Retardant 

Extruded PVC Inner Covering

Galvanized Steel Tape Armoured
Overall Sheath: polyvinylchloride (PVC) or FR-PVC, PE, LSOH

 

 

Technical data:

Test voltage 0.6/1 kV [kV] 3.5 / 5 min.
Temperature range in motion -5°C till +70°C
fixed -20°C till +70°C
Operating temperature short circuit °C 250
Short circuit time max. [sec] 5
Bending radius min. x diameter 15
Flammability standard EN 60332-1-2

 

 

 

 

Specifications

 

PVC insulated Electric Power Cable as IEC60502 and IEC60331, BS 6346 , DIN VDE 0271

 

We can produce PVC electric power cables with special requirement and higher properties according to the requirements of clients.

PVC electric power cables (plastic power cable) is one of high quality products of our company. The product not only has good electric capability, but also has good chemical stabilization, simple structure, easy to use, and the laying of cable do not be limited by the fall. It is widely used at the transformer circuit which rated voltage is 6000V or under.

 

The product can be produced against the standard of IEC60502 and IEC60331, BS 6346, DIN VDE 0271, and the standard required by the clients.

1. The long-term permissible operation temperature of the conductor shall not be higher than 70

2. The max temperature of the conductor of cable should less than 160 when short circuit. (less than 5 second)

3. The cable is not limited by drop in level when being laid, and the environment temperature shall not be lower than 0

4. Perfect chemical stability, resistant against acids, alkalis, grease and organic solvents, and flame retardant.

5. Light weight, perfect bending properties, installed and maintained easily and conveniently

6 Rated voltage: 0.6/1kV,~3.6/6kV or 0.6/1~1900/3300V

7 Number of cores: One, two, three, four, five

  

Certificates

 

 

Factory

 

 

 

 

You can contact me directly for soonest response 🙂